2003 HYD-MECH M-16A

USED HYD-MECH MODEL M-16A 16" X 25" FULLY AUTOMATIC HORIZONTAL MITERING BANDSAW, Stock# 11006, Year: 2003

Full capacity overhead bundling clamps
Mist lubrication
Digital head angle display
Variable vise pressure 
Mitering to 60 degrees
Full stroke vises
Powered blade chip brush
Chip auger
Heavy-duty motor and gearbox with variable frequency drive system
Carbide blade guides

We put our Bandsaws through a 20 Point Inspection and Repair Process assuring immediate performance when they hit your floor.

This machine has been fully refurbished including
1. Gear Reducer - Inspect for external signs of bearing or gear wear, i.e. excessive shaft play, gear lash, seal leakage or bearing noise. Replace parts as necessary.
2. Vari-Drive - (if applicable) Check condition. Check for pulley wear and alignment. Align if needed. Check condition of belt; check operation of powered speed changer if equipped. Recalibrate blade speed indicator. Replace parts as necessary.
3. Hydraulic System - Check for leaks; inspect solenoid valves, cylinders, gauges, fittings, etc. Replace parts as necessary.
4. Cam Followers - (Dual column machines) inspect and lubricate.
5. Blade Tension Assembly - Lubricate slider plate and adjust tension as necessary.
6. Hydraulic oil and filter - Inspect and replace as necessary.
7. Lubrication Points - Grease or oil all as required, i.e. idle wheel bearings, pivot points, guide rails, lead screws, pillow blocks and roller drive chain. Replace parts as necessary.
8. System & Cutting Pressures - Check and adjust.
9. Powered Blade Brush - Check for proper operation and replace as necessary.
10. Vises & Barfeed - Inspect all for vise plate wear and proper operation. Check operation and alignment of feed to saw.
11. Blade Guides - Inspect condition and replace as necessary.
12. Band Wheels - Inspect for excessive wear, crowning or taper and replace as necessary. Inspect idle wheel bearings and drive wheel run out. Replace as necessary.
13. Guide Arm Assembly - Check alignment, check that saw blade is square to vise and that the feed of the saw head is within specifications. Realign if necessary.
14. Blade Tracking - Inspect and adjust if necessary.
15. Feed System - Calibrate feed rate.
16. Coolant System - Check coolant pump operation and condition of coolant lines. Replace as necessary.
17. Electrical - Check all connections and secure if loose. Inspect cables and wires for fraying and insulation wear.
18. Control Switches - Check operation of all. Replace as necessary.
19. Limit Switches - Check adjustment and operation. Replace as necessary.
20. Final Run Off - Test run machine in all modes. Test cut and check parts for length accuracy and squareness.