2015 HEM HURRICANE 2030A

Used HEM FULLY AUTOMATIC HORIZONTAL MITERING BANDSAW, Hurricane 2030A Complete with Powered Conveyors (20’), 5’ Stock Table, 20”x30”, Stock No. 10513

Full capacity overhead bundling clamps on main and feed vise

Laser light

Powered blade chip brush

Blade break switch

Out of stock switch

Variable clamping pressure

Hydraulic blade tension

Powered miter with LED readout on control

Diagnostic panel

Kerf compensation

Chip auger

Full width discharge plate

5’ stock table for outfeed side

20’ powered conveyor for feed assist, VFD controlled and integrated with the saw controller. The rollers are controlled with

an “roller assist” mode for the indexing of larger loads. They will turn at a speed consistent with the speed of the indexing

barfeed. A 2 hp motor controlled by a Variable Frequency Drive and gear reducer drives the rollers.

Computer controlled Feed system consists of:

Feed to automatically cut up to 500 different jobs of various lengths from the same bar. Keyboard entry of job number,

number of parts to 999 pieces per job, parts length to 999.999 inches with automatic blade kerf compensation when

indexing, choice to display number of pieces cut or time per part. Control has adjustable off-set feature to correct length

while blade is dulling. Individual jobs can be bundled in up to 99 different programs each of which contain up to 5 steps

(jobs), in any order. Any of those 99 programs can be linked into a “Program Series” to run multiple programs

consecutively. With single source responsibility, HE&M Saw designed computer uses an Intel 8031 processor.

We put our Bandsaws through a 20 Point Inspection and Repair Process assuring immediate performance when they hit your floor.