Max. cutting cap. 90 deg, round: 20”
Max. cutting cap. 45 deg, round: 20”
Max. cutting cap. 30 deg, round: 13”
Max. cutting cap. 90 deg, rectangular: 20” x 30”
Max. cutting cap. 45 deg, rectangular: 20” x 20”
Max. cutting cap. 30 deg, rectangular: 20” x 13”
Max. degree of miter: 30 degree
Blade dimensions: 1-1/2” x 20’6” x .050”
Blade guides: Carbide
Guide arm (manual / powered): Powered
Blade speeds: 60 - 400 FPM
Number of speeds: Infinite
Blade motor: 10 H.P.
Blade drive type: Motor to gearbox
Blade tension type: Hydraulic
Hydraulic motor: 5 H.P.
Coolant type: Flood
Maximum feed length: 34”
Number of multi indexes: Up to 999”
Discharge Table Size: 24”
Vise type: Hydraulic
Currently Wired: 460 volt 3 phase
Dimensions: 95” x 142” x 82” saw only
Weight: 8,000 Lbs.
Full capacity overhead bundling clamps on main and feed vise
Powered blade chip brush
Blade break switch
Out of stock switch
Variable clamping pressure
Hydraulic blade tension
Powered miter with LED readout on control
Full width discharge plate
5’ stock table for outfeed side
20’ powered conveyor for feed assist, VFD controlled and integrated with the saw controller. The rollers are controlled with
an “roller assist” mode for the indexing of larger loads. They will turn at a speed consistent with the speed of the indexing
barfeed. A 2 hp motor controlled by a Variable Frequency Drive and gear reducer drives the rollers.
Computer controlled Feed system consists of:
Feed to automatically cut up to 500 different jobs of various lengths from the same bar. Keyboard entry of job number,
number of parts to 999 pieces per job, parts length to 999.999 inches with automatic blade kerf compensation when
indexing, choice to display number of pieces cut or time per part. Control has adjustable off-set feature to correct length
while blade is dulling. Individual jobs can be bundled in up to 99 different programs each of which contain up to 5 steps
(jobs), in any order. Any of those 99 programs can be linked into a “Program Series” to run multiple programs
consecutively. With single source responsibility, HE&M Saw designed computer uses an Intel 8031 processor.
We put our Bandsaws through a 20 Point Inspection and Repair Process assuring immediate performance when they hit your floor.